How to Take Apart a Soap Dispenser Pump

Do you have a soap dispenser pump that needs cleaning or repair? Taking apart a soap dispenser pump is a simple task that can be done in just a few minutes with the right tools and techniques. In this article, we will show you step-by-step how to take apart a soap dispenser pump to clean or replace the parts.

Gather the Tools

Before you start taking apart your soap dispenser pump, you will need to gather the necessary tools. You will need a flathead screwdriver, a pair of pliers, and a bowl or container to hold the parts.

Remove the Dispenser Pump from the Bottle

To start, remove the dispenser pump from the bottle by twisting it counterclockwise. If the pump is stuck, try pressing down on the top of the pump while twisting it to loosen it.

Remove the Top of the Pump

Once you have removed the pump from the bottle, use a flathead screwdriver to remove the top of the pump. Insert the screwdriver into the small slot on the side of the pump and gently pry it off.

Remove the Pump Mechanism

With the top of the pump removed, you will see the pump mechanism inside. Use a pair of pliers to grip the plastic tube that runs through the center of the pump and pull it out.

Disassemble the Pump Mechanism

Once you have removed the pump mechanism, you can disassemble it to clean or replace the parts. The pump mechanism consists of several parts, including the piston, spring, and ball bearing. Carefully remove each part and place them in a bowl or container.

Clean or Replace the Parts

With the pump mechanism disassembled, you can clean or replace the parts as needed. Use a mild soap and warm water to clean the parts, making sure to remove any dirt or debris. If any parts are damaged or worn, replace them with new ones.

Reassemble the Pump Mechanism

Once you have cleaned or replaced the parts, reassemble the pump mechanism in the reverse order of disassembly. Start by inserting the ball bearing into the plastic tube, followed by the spring and piston. Make sure each part is properly aligned and seated.

Reattach the Top of the Pump and Insert into the Bottle

With the pump mechanism reassembled, reattach the top of the pump by pressing it back into place. Insert the pump back into the bottle and twist it clockwise to secure it.

Test the Pump

Finally, test the pump to make sure it is working properly. Press down on the top of the pump to dispense soap. If the soap comes out smoothly and without any issues, your pump is ready to use.

Meta Description and Meta Keywords

Related video ofHow to Take Apart a Soap Dispenser Pump